63 lb/hr Siemens High-Z Fuel Injector MT

L107-L.jpg
L107-L.jpg

63 lb/hr Siemens High-Z Fuel Injector MT

45.00

TECHNICAL INFORMATION

Dynamically flowed and grouped to within 1% tolerance using Racetronix custom injector flow bench when purchased in packs. 
All tests run with n-Heptane @ 20oC (+/-1oC), 3.0 Bar (+/-0.01 Bar), 14VDC (+/-0.05VDC), saturated driver with RC cutoff.

Injector flow rates are based on testing with n-Heptane test solvent (0.6855 g/ml). U.S. EPA emission test gasoline 40CFR86.113 (0.735g/ml) flows in most common injector designs at about a 3 to 4% higher rate than n-Heptane. A ratio of 1.035:1 can be used when converting the flow specifications above.

This high-impedance injector will work with all factory ECM/PCM injector drivers.

Grease supplied to lubricate o-rings prior to installation

Add To Cart

TECHNICAL INFORMATION

Dynamically flowed and grouped to within 1% tolerance using Racetronix custom injector flow bench when purchased in packs. 
All tests run with n-Heptane @ 20oC (+/-1oC), 3.0 Bar (+/-0.01 Bar), 14VDC (+/-0.05VDC), saturated driver with RC cutoff.

Injector flow rates are based on testing with n-Heptane test solvent (0.6855 g/ml). U.S. EPA emission test gasoline 40CFR86.113 (0.735g/ml) flows in most common injector designs at about a 3 to 4% higher rate than n-Heptane. A ratio of 1.035:1 can be used when converting the flow specifications above.

This high-impedance injector will work with all factory ECM/PCM injector drivers.

ADDITIONAL INFORMATION

  • Grease supplied to lubricate o-rings prior to installation

Retail P/N:107961

MPN - Manufacturer P/N:FI114961

Static Flow lb/hr (n-Heptane):60.56

Static Flow cc/min:668

Static Flow Tolerance +/-%:6%

Dynamic Flow (mg/pulse):19.5

Dynamic Flow Tolerance +/-%:6%

Coil Resistance Ohms:12

Spray Pattern:Cone

Connector Type:Minitimer (Bosch EV1/LS1)

O-ring Type:Viton

E85 Compatible:YES

Weight (non-shipping):.08 lbs

Test Pressure PSI/KPa:43.5/300

Test Solvent:Heptane